Re: Linksys WUSB11 V 2.8; can't compile at76c503a sources

On Mon, 2004-01-19 at 15:48, Ian B. Jacobs wrote:
> On Mon, 2004-01-19 at 14:41, Joerg Albert wrote:

> >  Ian wrote:
> > > I have not been able to figure out what I need to do to compile
> > > successfully.
> > 
> > Sorry, my fault. The latest change didn't compile with < 2.4.23.
> > I've just fixed it in the cvs, guess tomorrow (MEST) it is in the
> > cvs snapshot. If impatient, use the cvs browser to look at e.g.
> > at76c503-rfmd.c around #include <linux/firmware.h> - same change in all
> > at76c50[35]-{i386[13],rmfd*}.c files.

Thank you for the fix; I was able to compile the driver.

> > > I also note that when I tried to use version 0.11 of the driver [1],
> > > I was able to compile and load the driver, but I was getting
> > > tremendous packet loss when pinging the machine with the WUSB11
> > > attached. Hence, I wanted to recompile from the source to see if that
> > > helped.
> > 
> > I fear it won't, as 0.12 was mainly a try to get a common source for 2.4
> > and 2.6 kernels. 

I didn't have much luck. The driver loads properly, but I still get
lots of packet loss. When I use a wired connection to the same
router, connectivity is not a problem.

I tried with both uhci and usb-uhci but didn't notice a difference.

Let me know if there's anything I can do to help out.

 _ Ian

-- 
Ian Jacobs ([email protected])   http://www.w3.org/People/Jacobs
Tel:                     +1 718 260-9447

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.3 (GNU/Linux)

iD8DBQBADKXT3Vu9UJRDGtARArU/AJ4nQ2aLsVgWrsjLtqHhj7npAUF8WgCgncsY
RmuUDt7iDWrPXWndDImKzg4=
=Gf6U
-----END PGP SIGNATURE-----