Pb with v 0.11 drivers + MA101 rev.B + Knoppix

Hi,

I got a ma101 rev.b usb installed on Knoppix. I a newbit (sorry) .
The connexion with the gateway is working corretly but .... I have to load 
manualy the driver each time I start Knoppix. I've filled 
etc/network/interfaces with all parameters, but :

I have to "ifdown" and "ifup" if I want to initialize and use the card.

Let's have a look on the commands :

# iwconfig
lo        no wireless extensions.
wlan0     IEEE 802.11-DS  ESSID:"okuwlan"  Nickname:"okuwlan"
          Mode:Ad-Hoc  Channel:10  Cell: 02:00:27:A5:EF:59
          Bit Rate:11Mb/s
          RTS thr=1536 B   Fragment thr=1536 B
          Encryption key:off
          Power Management:off
          Link Quality:0  Signal level:0  Noise level:0
          Rx invalid nwid:0  invalid crypt:0  invalid misc:0

The configuration is not yet loaded

-------------------------------------------------------------------------------
# ifup wlan0
ifup: interface wlan0 already configured
# iwconfig
lo        no wireless extensions.

wlan0     IEEE 802.11-DS  ESSID:"okuwlan"  Nickname:"okuwlan"
          Mode:Ad-Hoc  Channel:10  Cell: 02:00:27:A5:EF:59
          Bit Rate:11Mb/s
          RTS thr=1536 B   Fragment thr=1536 B
          Encryption key:off
          Power Management:off
          Link Quality:0  Signal level:20  Noise level:0
          Rx invalid nwid:0  invalid crypt:0  invalid misc:0

Very strange ... configuration seems loaded, but not applied (?)

-------------------------------------------------------------------------------

# ifdown wlan0
SIOCDELRT: No such process
# ifup wlan0
wlanctl-ng: Operation not supported
Failed to enable the device, exitcode= 1 .
run-parts: /etc/network/if-pre-up.d/linux-wlan-ng-pre-up exited with
return code                      1
wlanctl-ng: Operation not supported
Failed to enable the device, exitcode= 1 .
run-parts: /etc/network/if-pre-up.d/linux-wlan-ng_pre-up exited with
return code                      1

# iwconfig
lo        no wireless extensions.

wlan0     IEEE 802.11-DS  ESSID:"linksys"  Nickname:"linksys"
          Mode:Managed  Channel:11  Access Point: 00:06:25:**:**:7B
          Bit Rate:11Mb/s
          RTS thr=1536 B   Fragment thr=1536 B
          Encryption key:****-****-****-****-****-****-**  Security
mode:restricted
          Power Management:off
          Link Quality:0  Signal level:5  Noise level:0
          Rx invalid nwid:0  invalid crypt:0  invalid misc:0

I get an error message, but the configuration has been loaded this time, and 
the connexion is working...

If someone can help me :)

_________________________________________________________________
Trouvez l'âme soeur sur MSN Rencontres ! http://g.msn.fr/FR1000/9551