Re: Pb with v 0.11 drivers + MA101 rev.B + Knoppix

> > ----------------------------
> > auto lo
> > iface lo inet loopback
> > auto wlan0
> >
> > iface wlan0 inet static
> > 	address 192.168.1.100
> > 	netmask 255.255.255.0
> > 	network 192.168.1.0
> > 	broadcast 192.168.1.255
> > 	gateway 192.168.1.1
> > 	wireless_key ************************** restricted
> > 	wireless_essid linksys
> > 	wireless_mode managed
> > 	wireless_nick linksys
> > ------------------
>
>I'd remove "auto wlan0" - you cannot start this interface
>at boot time, but after the insertion of the device was detected - even if
>the device _is_ plugged-in during boot, the firmware download does take
>time. Be sure to have the hotplug package installed.
>
>I'm still confused about the wlanctl-ng from your previous post...
>
>/Jörg

I'm sorry guyz :
I've deleted "auto wlan0".
When I boot with the device connected, the problem still there. I got the 
same thing, the card is not configured at boot timen, and I've to do that :
----
#ifdown wlan0
SIOCDELRT: No such process
#ifup wlan0
wlanctl-ng: Operation not supported
Failed to enable the device, exitcode= 1 .
run-parts: /etc/network/if-pre-up.d/linux-wlan-ng-pre-up exited with return 
code 1
wlanctl-ng: Operation not supported
Failed to enable the device, exitcode= 1 .
run-parts: /etc/network/if-pre-up.d/linux-wlan-ng_pre-up exited with return 
code 1
----

but the configuration is loaded, and I can used normaly the ma101 revB.

Note that at boot time, I can see that hotplug package is normaly installed.
Any other ideas ? (Sorry for disturbation...)

_________________________________________________________________
Hotmail : un compte GRATUIT qui vous suit partout et tout le temps ! 
http://g.msn.fr/FR1000/9493