Re: statistics always zero?
Alex Schultz <[email protected]>
| Newsgroups | gmane.linux.drivers.at76c503a.user |
|---|---|
| Message-ID | <[email protected]> |
Hi,
If I remember correctly, this driver doesn't return the link quality,
signal level, and noise level statistics, it isn't intended to.
Al
Christopher Piggott HOME wrote:
>What would make link quality, signal level, and noise level statistics
>always zero, even though it's working?
>
>
>wlan0 IEEE 802.11-DS ESSID:"Wireless" Nickname:"Jeep"
> Mode:Managed Channel:7 Access Point: 00:30:AB:16:1F:4E
> Bit Rate:11Mb/s Tx-Power=15 dBm
> Retry limit:8 RTS thr=1536 B Fragment thr=1536 B
> Encryption key:DEAD-BABE-BEEF-BABE-B00B-BABE-EE Security
>mode:restricted
> Power Management:off
> Link Quality:0 Signal level:0 Noise level:0
> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
> Tx excessive retries:0 Invalid misc:0 Missed beacon:0
>
>
>_______________________________________________
>at76c503a-user mailing list
>[email protected]
>http://lists.berlios.de/mailman/listinfo/at76c503a-user
>
>
>