Re: SMC2662W V.4

Hi Alex,

On Sat, 3 Jul 2004, Alex Schultz wrote:

> Hi,
>
> The keyboard lockups are being worse than ever (rather unbearable,
> lasting at least 30 min). Here's a more updated dmesg with possibly
> better diagnostic info:
>
> Pre-module-load complaints about the card
> -------------------------------------------
>
> drivers/usb/host/uhci-hcd.c: uhci_result_control() failed with status 440000
> [c130c270] link (0130c1e2) element (0130d100)
>   0: [c130d100] link (0130d140) e0 Stalled CRC/Timeo Length=7 MaxLen=7 DT0 EndPt=0 Dev=3, PID=2d(SETUP) (buf=01310a80)
>   1: [c130d140] link (0130d180) e3 SPD Active Length=0 MaxLen=7 DT1 EndPt=0 Dev=3, PID=69(IN) (buf=01310aa0)
>   2: [c130d180] link (00000001) e3 IOC Active Length=0 MaxLen=7ff DT1 EndPt=0 Dev=3, PID=e1(OUT) (buf=00000000)
> ...

no idea where this activity come from (never seen these errors before).
Do you have CONFIG_USB_DEVICEFS=y in your .config? Try without.

> And now I load the drivers:
> ---------------------------
> ...
> And then it finally works (spending over half an hour VERY slowly going
> through the internal (and maby external as well) firmware download). Do
> you have any idea why (and possibly a workaround/fix for)  it's getting
> stuck downloading the firmware?

no, sorry. Downloading the firmware to the device usually takes seconds,
not half an hour. Maybe some other software tries to access the device.
I'm off for the next three days - will look closer into these error msgs
afterwards.

/Jörg