Can't seem to associate with an access point... (?)

"Steve Neuharth" <[email protected]>
Newsgroups gmane.linux.drivers.at76c503a.user
Message-ID <[email protected]>
Ok. I'm running kernel 2.6 and using the latest code from CVS:

 

root@simian steve # dmesg | head

Linux version 2.6.7-gentoo-r11 (root@simian) (gcc version 3.3.3 20040412
(Gentoo Linux 3.3.3-r6, ssp-3.3.2-2, pie-8.7.6)) #1 Thu Jul 22 14:14:50
Local time zone must be set--see zic manu

 

The driver seems to load fine. It detects and downloads the firmware from my
WUSB11 (2.6, I believe):

 

/usr/src/CVS/usbdfu.c: USB Device Firmware Upgrade (DFU) handler v0.12beta14
loading

/usr/src/CVS/at76c503.c: Generic Atmel at76c503/at76c505 routines
v0.12beta14

/usr/src/CVS/at76c503-fw_skel.c: Atmel at76c505 (RFMD 2958) Wireless LAN
Driver v0.12beta14 loading

/usr/src/CVS/at76c503-fw_skel.c: using compiled-in firmware

/usr/src/CVS/at76c503.c: $Id: at76c503.c,v 1.61 2004/06/29 21:26:24 jal2 Exp
$ compiled Jul 23 2004 09:24:38

/usr/src/CVS/at76c503.c: firmware version 1.101.0 #86 (fcs_len 4)

/usr/src/CVS/at76c503.c: device's MAC 00:0c:41:fb:56:c7, regulatory domain
FCC (U.S) (id 16)

/usr/src/CVS/at76c503.c: registered wlan0

usbcore: registered new driver at76c505-rfmd2958

 

I cannot, however, see my access point: 

 

root@simian steve # iwlist wlan0 scanning

wlan0     No scan results

root@simian steve # iwconfig             

lo        no wireless extensions.

 

wlan0     IEEE 802.11-DS  ESSID:"supermonkeycollider"  Nickname:"simian"

          Mode:Managed  Channel:6  Access Point: 00:00:00:00:00:00  

          Bit Rate:11Mb/s   Tx-Power=15 dBm   

          Retry limit:8   RTS thr=1536 B   Fragment thr=1536 B   

          Encryption key:off

          Power Management:off

          Link Quality:0/0  Signal level:-149 dBm  Noise level:-256 dBm

          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0

          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

 

eth0      no wireless extensions.

 

The AP IS up and running, operating on channel 6, I use my laptop on it just
fine.

 

I'm pretty sure that this is just a "user error" typa thing bit I'm just
plain stuck. Does anyone have any ideas?
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.