Re: Knoppix Hints for activating - Yes I'm a newbie

This is using Knoppix 3.4, May 10th release. I've tried both the
regular and the experimental kernels.

Neither one will detect the card either plugged in at boot, or plugged
in after the desktop is up.

The 2.6 kernel does not seem to be setup properly to use the right
paths for kernel source.

The 2.4 kernel looks to be setup ok, but I'm not sure which version of
the kernel source I'm looking for.

Thanks,
Ewan

On Tue, 03 Aug 2004 22:40:57 +0800, Nick Jones
<[email protected]> wrote:
> Which version of knoppix is that?  What version of the kernel does it run?
> 
> Thanks
> 
>   Nick
> 
>
> Ewan Grantham wrote:
> 
> >I had successfully compiled and installed the driver under
> >Lindows/Linspire 4.5 on a computer I used to have. Am now trying to
> >setup Linux again on a different computer, and wanted to go with the
> >Knoppix distribution - in part because the new computer is actually an
> >old computer and Linspire crawls...
> >
> >However, I don't seem to be having any luck getting my Linksys WUSB11
> >v2.8 device (same one I used to use before) to come up under Knoppix,
> >and am having equally limited success figuring out how to get the
> >driver to compile.
> >
> >Anyone else who's been through this before and could point me in the
> >right direction, I'd appreciate it.