Gigafast WF741-UIC has different vend/prod ID

Howdy.  I own a Gigafast WF741-UIC USB wifi "stick", which should be
supported by the atmel driver (its in the table).   However, the driver
doesn't install when I plug it in, because the vendor id/ product id is
different than in the table.

I have: 0xace : 0x1201

The table has: 0X3eb : 0x7603

I have tried putting these new ID's in config.h, but to no avail.  It
says usb device is not accepting new address.

I am being silly, and Gigafast is not using an atmel chip, or is there
another config I can change so it sees these ID's as the Gigafast
adapter?

Thanks for your time,
Rex