HP Ipaq 5450

I've been able to compile and load the usbvnetr driver onto a HP Ipaq
5450 running Familiar Linux 2.4.19. When the driver loads, I receive
several driver inititialization messages and it ends with saying it's
scanning. An eth0 interface is presented to me that looks good. When I
run lvnet, I can read the configuration from the at76c503a chip,
however, trying to change any of the options like the essid immediately
locks up the PDA. Has anyone else have any better success with using the
atmelwlandriver on the Ipaq 5450?

Also, if I wanted to add wireless extensions to the usbvnetr driver,
what source files would be the appropriate place to add the defines and
includes?

Thanks,

-- 
Glen T. Kondos <[email protected]>