Re: Kernel Panic with atmelwlandriver 2.1.2.2

Hello again,

>>>>After trying out a Netgear MA311 (which works perfectly, but not with my AP)
>>>>        
>>>>
>>>What's the problem with your AP? Did you try both wlan-ng and host_ap?
>>>      
>>>
>>It's not my own AP, I wanted to say that my Internet-AP (which I dont
>>control)
>>does not like some hardware, like most of the D-Link Products.. Its bad
>>but I cannot do anything to change it...
>>    
>>
>
>What's the brand of this AP? You don't have an airtrace of the
>failed association with this AP (e.g. by a second Prism2 (Orinoco?)
>device)?
>
It is an Orinoco ROR 1000 AP. Airtracing could become a problem, because its
an long range link (with extra antenna). I dont have a second antenna to 
catch
both rx and tx packets...

>>>No idea about the reason of the above problem, but could you try:
>>>
>>>c) the Berlios OS driver (http://at76c503a.berlios.de/)
>>>      
>>>
>>How stable is the Berlios Driver, can you say something "general" about it?
>>    
>>
>
>  
>
|  IMHO at least as stable as the Sourceforge one; there were few reports

>about crashes/locking devices mainly related to some old revision of USB
>host controllers which I couldn't reproduce at my site (run ~8 GByte thru
>it). And IMHO it's much easier to solve problems at your site (than with
>the SF one) due to its debugging output.
>
>Where do you want to use it?
>  
>
The Berlios Driver solved all my problems.. Everything I need works
fine now.. But I am still wondering about the netgear/prism issue....

thx,
   Andre.