Re: eth2: unknown interface: No such device

Andre Küster writes: 

> Hi, 
> 
> Fabio Antonini wrote: 
> 
>> 
>> If I try to configure eth2 by hand with iwconfig
>> I receive the following message
>> eth2:   no such device
>> The eth2 interface is unknown. Probably I haven't set up correctly the 
>> eth2 and this is a "absolute beginner" question and this isn't the most 
>> right place where to ask for help about this item, but I hope that anyone 
>> could help me. Any suggest will be appreciated.
> 
> Are you sure, that eth2 is the right device? I use the same driver 
> (version 0.11beta3)
> and the default name for the created wlan-device is wlan0 here... 
> 
> Andre. 
> 
> _______________________________________________
> Atmel-wlan-usb mailing list
> Atmel-wlan-usb-ikZNBd7uB5wQUIZIPwn63sWURRETrGNnG9Ur7JDdleE@public.gmane.org
> https://iprserv.jura.uni-leipzig.de/mailman/listinfo/atmel-wlan-usb
On my board I 've already two wired network interfaces eth0 and eth1. So I 
thought that the first name available were eth2. Now I want to try with 
wlan0. I hope to have good news in a couple of minutes.
Thank you for your time
Fabio 


Fabio Antonini
Kasko Networks S.r.l.
Via Patini 46 67100 L'Aquila - Italy
Ph/Fax +3986265562
e-mail: [email protected]