Re: Linksys WUSB 2.6 not working well?!

Configure /root/.vnetrc to your settings then run the script:

/bin/fastvnet.sh

--- Eng Se-Hsieng <[email protected]> wrote:
> I have installed the atmel drivers for my Linksys WUSB 2.6 card in
> Redhat 7.3 but I am consistently unable to connect to the Access Point
> using the command:
> iwconfig eth0 essid myessid
> 
> In dmesg:
> 
> hub.c: USB new device connect on bus1/1, assigned device number 3
> usb.c: USB device 3 (vend/prod 0x77b/0x2219) is not claimed by any
> active driver.
> usb.c: registered new driver usbvnetr
> usb_vnet_probe: usb vendor/product=77b/2219
> vnet_kernel.c: Reseting Usb Device
> 
> usb.c: USB disconnect on device 3
> usb.c: ignoring set_interface for dev 3, iface 0, alt 0
> vnet_kernel.c: Reset completed.
> Reg Domain
> vnet.c: StartUp failed
> vnetusba.c: device initialization failed
> hub.c: USB new device connect on bus1/1, assigned device number 4
> usb_vnet_probe: usb vendor/product=77b/2219
> Reg Domain
> usbvnetr: driver version 1.0.1.101, compiled Jul 17 2003 21:11:14
> (dbg_mask x0)
> MAC addr 00:0C:41:0A:A0:78 firmware 0.90.2.140
> Multicast is enabled
> vnetusba.c: usb eth0 initialized and registered
> usbdevfs: USBDEVFS_CONTROL failed dev 4 rqt 128 rq 6 len 18 ret -6
> usbdevfs: USBDEVFS_CONTROL failed dev 4 rqt 128 rq 6 len 18 ret -6
> usbdevfs: USBDEVFS_CONTROL failed dev 4 rqt 128 rq 6 len 18 ret -6
> vnetusba.c: Device eth0 closed
> vnetusba.c: Device eth0 closed
> vnetusba.c: Device eth0 closed
> vnetusba.c: Device eth0 closed
> 
> Pleae help!
> 
> Thank you.
> 
> Regards,
> Se-Hsieng
> 
> _______________________________________________
> Atmel-wlan-usb mailing list
> Atmel-wlan-usb-ikZNBd7uB5wQUIZIPwn63sWURRETrGNnG9Ur7JDdleE@public.gmane.org
> https://iprserv.jura.uni-leipzig.de/mailman/listinfo/atmel-wlan-usb


__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com