Re: eth2: unknown interface: No such device
"Fabio Antonini" <[email protected]>
| Newsgroups | gmane.linux.drivers.atmel-wlan |
|---|---|
| Message-ID | <[email protected]> |
Joerg Albert Scrive:
> Hi Fabio,
>
>> if I get the command iwconfig to configure I read strange values for the bit
>> rate and the channel!!
>> take a look:
>>
>> sh-2.04# iwconfig wlan0 channel 6 mode ad-hoc essid linksys
>> sh-2.04# iwconfig wlan0
>> wlan0 IEEE 802.11-DS ESSID:"linksys" Nickname:"okuwlan"
>> Mode:Ad-Hoc Channel:2.11367e-314 Cell: 00:00:00:00:00:00
>> Bit Rate:1.89593e-77Mb/s
>
> what's your iwconfig version ("iwconfig --version")?
>
> /Jörg
>
> _______________________________________________
> Atmel-wlan-usb mailing list
> Atmel-wlan-usb-ikZNBd7uB5wQUIZIPwn63sWURRETrGNnG9Ur7JDdleE@public.gmane.org
> https://iprserv.jura.uni-leipzig.de/mailman/listinfo/atmel-wlan-usb
Hi Jorg
the iwconfig is 26...the last I think. In my opinion the problem is related
to the crosscompilation process and in particular to the big-endian/little
endian support. Infact my processor is a ppc405 and is endianess is big
endian. Could this be the problem. I go on in the investigation. Thank for
your help.
Fabio
Fabio Antonini
Kasko Networks S.r.l.
Via Patini 46 67100 L'Aquila - Italy
Ph/Fax +3986265562
e-mail: [email protected]