RE: Can't get 100/full duplex with bcm5700...

What is the version of bcm5700 are you using?

-----Original Message-----
From: Ken Kleiner [mailto:[email protected]] 
Sent: Thursday, May 22, 2003 2:15 PM
To: [email protected]
Subject: Can't get 100/full duplex with bcm5700...


Hi...

 I'm running RH AS 2.1 on a DELL 2650 with bcm5700 driver.  On boot
(w./out any module config), I get the following in /var/log/messages:

May 22 17:08:58 systemname kernel: bcm5700: eth0 NIC Link is UP, 100
Mbps half duplex

 The switch port on the other end is set to 100MB Full duplex.

 I put the following in /etc/modules.conf and rebooted.  Doing that
causes the card to not come up at all (i.e. eth0: link is down).

alias eth0 bcm5700
options eth0 line_speed=100 full_duplex=1
 
 Is there something I'm missing?  Thanks....


-- 
<><  ><> <><  ><> <><  ><> <><  ><> <><  ><> <><  

Ken Kleiner
System Manager
Computer Science Department
Umass Lowell

voice : 978 934 3645
fax : 978 934 3551

cell : 603 930 5582 (emergencies only, please)

[email protected]


_______________________________________________
broadcom-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/broadcom-list