Re: siano firmware and behaviour after resuming power
Luca Olivetti <[email protected]>
| Newsgroups | gmane.linux.drivers.dvb |
|---|---|
| Message-ID | <[email protected]> |
En/na BOUWSMA Barry ha escrit: >> I found a something here >> >> http://marc.info/?l=linux-usb-users&m=116827193506484&w=2 >> >> that purportedly resets an usb device. >> What I tried was, before powering off: >> >> 1) unload the drivers >> 2) use the above to reset the stick >> 3) power off >> >> and, before loading the drivers, issue a reset again. >> Sometimes it works, sometimes it doesn't, the end result is that I cannot >> leave the device plugged-in if I want to use it. > > That might work for a planned reboot This being a vdr machine, the reboot is either planned or due to a power loss, and I suppose that the latter would really reset the device, but I didn't try. The problem is that even so (planned reboot/switch off) it only works sometimes. > -- my reboots are > occasionally unplanned, and the devices are in part hanging > at boot time. I guess if I had had the patience to watch and > see if the wait eventually timed out, I could test just how > the system came up and reset anything not present (and then > configure it as needed). Too much work for a non-critical > system, when I'd rather it Just Work. > > I am lazy. So sue me :-) As I'm getting older, I'm also getting lazier, so I'm not going to sue you ;-) Bye -- Luca _______________________________________________ linux-dvb users mailing list For V4L/DVB development, please use instead [email protected] [email protected] http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb