dib0700: Nova-T-500 remote - mixed button codes
Antonio Marcos López Alonso <[email protected]>
| Newsgroups | gmane.linux.drivers.dvb |
|---|---|
| Message-ID | <[email protected]> |
Hi all, I own a Hauppauge Nova-T-500 in a box running Mythbuntu 9.10. The card runs fine except when it comes to the in-built remote sensor: Whenever I press any button, the remote sensor seems to receive some other keycodes aside the proper one (i.e. when I press Volume Up button the sensor receives it most of the time, but sometimes it understands some other buttons are pressed like ArrowDown, Red button and so, making MythTV experience very annoying). There are only three buttons that are always well received with no confusion at all: "OK", "ArrowDown" and "Play". This behavior occurs with two identical remotes I own (one of them belonging to a WinTV HVR-1100) and another card user has reported a similar behavior with its own and same remote. I tested both remotes with the HVR-1100 and they behave perfectly, so I guess this is not a remote related issue. Though I have tried several LIRC setup files and swapped dvb_usb_dib0700 firmware files (1.10 and 1.20 versions) they make no working difference at all. I also tried rebuilding v4l-dvb code to no avail. Any suggestions? I would gladly provide further info/logs upon request. Cheers, Antonio _______________________________________________ linux-dvb users mailing list For V4L/DVB development, please use instead [email protected] [email protected] http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb