USB1.1 vs. USB2.0

Hi all!

When i insert a USB 2.0 device i get the following errors:

[   93.680054] usb 2-1: new full speed USB device using uhci_hcd and address
3
[   93.843342] usb 2-1: configuration #1 chosen from 1 choice
[   93.855095] input: HID 18b4:1001 as
/devices/pci0000:00/0000:00:1d.1/usb2/2-1/2-1:1.0/input/input12
[   93.855916] generic-usb 0003:18B4:1001.0002: input,hidraw0: USB HID v1.11
Keyboard [HID 18b4:1001] on usb-0000:00:1d.1-1/input0
[   93.866130] dvb-usb: found a 'E3C EC168 DVB-T USB2.0 reference design' in
cold state, will try to load a firmware
[   93.866151] usb 2-1: firmware: requesting dvb-usb-ec168.fw
[   94.212405] dvb-usb: downloading firmware from file 'dvb-usb-ec168.fw'
[   94.317243] dvb-usb: found a 'E3C EC168 DVB-T USB2.0 reference design' in
warm state.
[   94.317401] dvb-usb: This USB2.0 device cannot be run on a USB1.1 port.
(it lacks a hardware PID filter)
[   94.317471] dvb-usb: E3C EC168 DVB-T USB2.0 reference design error while
loading driver (-19)
I've seen this message many times when searching the internet for a
solution, but i haven't found the solution yet.

Does anybody know how to solve this?

This is Ubuntu 2.6.32.8-1 on an EeePC 701. And yes, this machine does have
USB 2.0 ports.

Thanks,

Ton.

_______________________________________________
linux-dvb users mailing list
For V4L/DVB development, please use instead [email protected]
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb