Re: RedHat 7.3 & vpn client 3.5.2 on T23
Michael Barnes <[email protected]>
| Newsgroups | gmane.linux.drivers.eepro100.devel |
|---|---|
| Message-ID | <[email protected]> |
Donald Becker wrote: > > On Fri, 21 Jun 2002, Michael Barnes wrote: > > Donald Becker wrote: > > > On Fri, 21 Jun 2002, Michael Barnes wrote: > > > > Donald Becker wrote: > > > > > On Fri, 21 Jun 2002, Michael Barnes wrote: > > > > > > I just got an IBM T23, installed RedHat 7.3, and did up2date. > > > > > > Jun 21 13:56:23 dhcp-2545-22 kernel: eepro100: wait_for_cmd_done timeout! > > > > > .. > > > > > > Jun 21 13:58:27 dhcp-2545-22 kernel: NETDEV WATCHDOG: eth0: transmit timed > > > > > > out > > > > > > Jun 21 13:58:27 dhcp-2545-22 kernel: eth0: Transmit timed out: status 0050 > > > > > > 0c80 at 30928/30988 command 200c0000. > > > ... > > > > > > I saw in the archive a message that suggests to disable sleep mode, but I > > > > > > can't find instructions on how to do that, if that would help. > > > > > Run > > > > > eepro100-diag -ee > ... > > Sleep mode is enabled. This is not recommended. > > Under high load the card may not respond to > > PCI requests, and thus cause a master abort. > > To clear sleep mode use the '-G 0 -w -w -f' options. > ... > > [root@localhost eepro100-diag]# ./eepro100-diag -G 0 -w -w -f > > eepro100-diag.c:v2.08 4/17/2002 Donald Becker ([email protected]) > > Writing 49a0 to configuration word 10. > > OK, that clears the sleep mode bit, which causes PCI protocol errors. > You must cold power cycle the machine for this to take effect. (There > is no way for the driver to clear the bit during operation, or the > EEPROM-setting step wouldn't be needed.) Okay, I was lazy and didn't do the cold power cycle before. After that it does seem to be working just fine. Thank you! > > -- > Donald Becker [email protected] > Scyld Computing Corporation http://www.scyld.com > 410 Severn Ave. Suite 210 Second Generation Beowulf Clusters > Annapolis MD 21403 410-990-9993 -- Michael Barnes Core IP Eng - Routing 408-525-2785