Re: [eepro100-bug] two i82559 on board do not work

Donald Becker wrote:

>On Wed, 25 Sep 2002, Anton Yurchenko wrote:
>
>  
>
>>I have a Tyan LE-T Dual CPU motherboard 
>>(http://www.tyan.com/products/html/thunderlet.html), it is based on 
>>ServerWorks III LE3 chipset, with two i82559 controllers.
>>I`m running RedHat 7.3, uname -a:
>>    
>>
>...
>  
>
>>eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html
>>eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin <[email protected]> 
>>and others
>>eth0: Intel Corp. 82557/8/9 [Ethernet Pro 100], 00:E0:81:21:03:DC, IRQ 20.
>>    
>>
>...
>  
>
>>eth1: Intel Corp. 82557/8/9 [Ethernet Pro 100] (#2), 00:E0:81:21:03:DD, IRQ 21.
>>  Board assembly 567812-052, Physical connectors present: RJ45
>>  Primary interface chip i82555 PHY #1.
>>Self test failed, status ffffffff:
>> Failure to initialize the i82557.
>> Verify that the card is a bus-master capable slot.
>>    
>>
>
>OK, you have a failure of some sort.
>You can read the configuration EEPROM, but the chip can't operate on the bus.
>It appears that the card isn't enabled as a bus master, or the modified
>driver you are using isn't initializing the chip correctly.
>  
>
I tried the stock 2.4.19 kernel and had the same problem. Tyan( they are 
the borad manufacturers) said to flash the new BIOS, which didn`t help a 
bit. The next thing that they sujjested was changing the board. I do not 
see any option in BIOS to enable/disable bus master for the ethernet 
cards. Or is it some option in the kernel? I also have problems with 
using the second interface with Intel e100 driver.

-- 

Anton Yurchenko<[email protected]>
Digital Generation