Re: Speed and Duplexing, Once Again
Donald Becker <[email protected]> Thu, 17 Oct 2002 17:42:51 -0400 (EDT)
| Newsgroups | gmane.linux.drivers.eepro100.devel |
|---|---|
| Message-ID | <[email protected]> |
On Thu, 17 Oct 2002, Danish Mirza wrote: > So now Im using tg3 drivers to work with gige. > I've configure the box to come up on the network. > I even forced the the interface using ethtool command: > ethtool -s eth0 autoneg on speed 1000 duplex full > > Then I use the mii-tool -v to show the speed it shows: I didn't write those tools. You should consult their documentation. -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Scyld Beowulf cluster system Annapolis MD 21403 410-990-9993