Re: eepro100 and e1000

Try to patch the driver only searching for "one" VENDOR_ID/CHIP_ID
on the PCI bus.

Christoph P.


Nate Amsden wrote:
> 
> Claus Rosenberger wrote:
> >
> > hi,
> >
> > i want to use the eepro100 and the e1000 in the same machine. until now i
> > compiled modules and had some alias eth0 and eth1 for this cards. but now
> > i want to build the drivers staticly to the kernel. how i can force to
> > load the eepro100 as device eth0 and the e1000 as device eth1 ?
> > the kernel load the devices all the time in wrong order.
> 
> change the order of the PCI cards, the kernel should assign them in the order
> that they are detected, so if they are PCI cards, flip em around, and
> it should get reversed. if one is onboard ..well I am not sure what
> you can do.
> 
> nate
> 
> --
> Nate Amsden
> System Administrator
> GraphOn
> http://www.graphon.com
> _______________________________________________
> eepro100 mailing list
> [email protected]
> http://www.scyld.com/mailman/listinfo/eepro100

-- 
  +--------V--------+	[email protected]
  |  A L C A T E L  |	-----------------------------
  +-----------------+	Phone: +43 1 27722 3706	
         T A S		Fax:   +43 1 27722 3955