eepro100 startup problem on PPC8245

Hello,
We use two 82559 MAC/PHY controllers on an embedded system based on a
PowerPC 8245 running Hardhat 2.1 from Montavista.
The system is booted using NFS to mount the root filesystem. The system
isn't able to mount the NFS root upon normal startup (without JTAG probe or
hardware reset). The MAC/PHY doesn't send any packet although the kernel
reports that everything is going well. we use the eepro100 driver. After
some reset with te JTAG probe, it send packets without problem.
Note that the interrupt lines of the 82559 are directly wired to the
Interrupt controller of the PPC (changes made and working)

Best regards,
----------------------------------------------------------------------------
------
Benoit Callebaut
Software Development Engineer
Barco | Control Rooms
Noordlaan 5, 8520 Kuurne, Belgium
 
Tel 	+32(0)56 36 84 28
Fax 	+32(0)56 36 86 05

mailto:[email protected]
http://www.barcocontrolrooms.com

- - - - - - - DISCLAIMER - - - - - - - -
Unless indicated otherwise, the information contained in this message is
privileged and confidential, and is intended only for the use of the
addressee(s) named above and others who have been specifically authorized to
receive it. If you are not the intended recipient, you are hereby notified
that any dissemination, distribution or copying of this message and/or
attachments is strictly prohibited. The company accepts no liability for any
damage caused by any virus transmitted by this email. Furthermore, the
company does not warrant a proper and complete transmission of this
information, nor does it accept liability for any delays. If you have
received this message in error, please contact the sender and delete the
message. Thank you.