Re: How to establish M2M communication with gammu?
João M. S. Silva <[email protected]>
| Newsgroups | gmane.linux.drivers.gammu |
|---|---|
| Message-ID | <[email protected]> |
Hi, I tried gammu identify and it worked. Then I tried wvdialconf again and now it worked, it created a default configuration file. Previously this command failed. With the automatically created configuration file + customization, wvdial works. I had to use the complete name for the APN, e.g.: Init3 = AT+CGDCONT=1,"ip","internet.vodafone.pt" not just "internet" like in some tools. Thank you all! João M. S. Silva On 10/29/2015 02:22 AM, gilberto dos santos alves wrote: > hi. > your baud rate is set to 115200 see that [1] at page 30 explain that > autobaud max is 57600bps. > > please make detail tests using vdialconf and look at your dmesg say > after detect your device and after following tutorial point by > braincrash nxs. try work with defaults that wvdialconf detects. wvdial > works and gammu will works, try gammu identify to understand gammu > detections. > > [1] > http://www.headele.com/Datasheet/Wireless%20module/GPRS/SIMCOM/SIM800L_Hardware_Design_V1.00.pdf > > 2015-10-27 23:36 GMT-02:00 João M. S. Silva > <[email protected] <mailto:[email protected]>>: > > Hi Braincrash, > > Obrigado :) > > I tried your howto for Vodafone with this wvdial.conf file: > > [Dialer SIM800L] > Init1 = ATZ > Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0 > Init3 = AT+CGDCONT=1,"IP","internet" > Stupid Mode = 1 > Modem Type = Analog Modem > ISDN = 0 > Phone = *99# > Modem = /dev/ttyUSB0 > Username = { } > Password = { } > Baud = 115200 > > but: > > $ wvdial --config=wvdial.conf SIM800L > --> WvDial: Internet dialer version 1.61 > --> Cannot set information for serial port. > --> Initializing modem. > --> Sending: ATZ > --> Sending: ATQ0 > --> Re-Sending: ATZ > --> Modem not responding. > > However, if I connect with miniterm.py I can normally send the AT > commands. > > Maybe it's because the serial SIM800L module is connected to the PC > through a serial-to-USB converter? > > João M. S. Silva > > On 10/27/2015 04:28 PM, braincrash nxs wrote: > > João, I'm Portuguese, if you want I can try to help you with that, You > > can have the 4G dongle to automatically register on the GSM network and > > authenticate the dialer. > > > > Follow this tutorial for our country. > > > >http://myhowtosandprojects.blogspot.pt/2013/12/how-to-setup-usb-3g-modem-linux.html > > > > Thanks. > > > > On Tue, Oct 27, 2015 at 3:52 PM, João M. S. Silva > > <[email protected] > <mailto:[email protected]> > <mailto:[email protected] > <mailto:[email protected]>>> > > wrote: > > > > I'm using Ubuntu 14.04.3. > > > > Thanks, wvdial is a nice suggestion. I never used it, if I remember > > correctly, but I've read about it. > > > > João M. S. Silva > > > > On 10/27/2015 03:29 PM, gilberto dos santos alves wrote: > > > please are you using linux (what distrib) or windows (what version 32 / > > > 64bits)? > > > > > > if on windows your stick already have standard cd/dvd driver that has > > > standard dial-up to connect web (for example zte MF190 HSUPA usb stick). > > > > > > if on linux you could use your terminal dial-up (pppd) package wvdial > > > IMHO is very ease to use. > > > > > > 2015-10-27 11:48 GMT-02:00 Ulf <[email protected] <mailto:[email protected]> > <mailto:[email protected] <mailto:[email protected]>> > > > <mailto:[email protected] <mailto:[email protected]> > <mailto:[email protected] <mailto:[email protected]>>>>: > > > > > > I never tried this. > > > If you find a solution with NetworkManager, I would be > > interested on > > > a feedback. > > > > > > -Ulf > > > > > > > > > Am 27.10.2015 um 13:55 schrieb João M. S. Silva: > > > > Thanks for your answers. > > > > > > > > OK, if I understood correctly, I can use gammu for > SMS and > > USSD. > > > > > > > > But I should use, NetworkManager, for instance, to > connect > > to the > > > Internet. > > > > > > > > Is this correct? > > > > > > > > João M. S. Silva > > > > > > > > On 10/27/2015 12:19 PM, Ulf wrote: > > > >> Hi Brain, > > > >> > > > >> I think, the question is, how to "configure the > device to > > > automatically connect to the internet > > > >> trough 4G". > > > >> > > > >> It seems, João wants to do this with help of gammu. > > > >> > > > >> Hope that helps, > > > >> > > > >> Ulf > > > >> > > > >> > > > >> Am 27.10.2015 um 13:07 schrieb Brain crash: > > > >>> Hi, > > > >>> > > > >>> If I correctly understood your question, you just > need > > two USB > > > dongle or 2 SIM cards that suport data, each operator in > > Portugal as > > > them, you configure the device to automatically > connect to the > > > internet trough 4G that way you will have in each > device an IP > > > address which simplifies that rest. > > > >>> > > > >>> Sent from my iPhone 4S > > > >>> > > > >>> No dia 27/10/2015, às 12:01, João M. S. Silva > > > <[email protected] > <mailto:[email protected]> > > <mailto:[email protected] > <mailto:[email protected]>> > > > <mailto:[email protected] > <mailto:[email protected]> > > <mailto:[email protected] > <mailto:[email protected]>>>> escreveu: > > > >>> > > > >>> Hi Gilberto, > > > >>> > > > >>> I've asked for M2M solutions to Portugal > operators. Only > > Vodafone > > > >>> answered and basically they just sell a SIM card > which > > allows > > > data traffic. > > > >>> > > > >>> Using a card like this in a SIM800L module, I can > > send/receive > > > SMS and > > > >>> also run USSD commands. > > > >>> > > > >>> But what I need is to communicate between two > machines using > > > the same > > > >>> hardware. If I use SMS, it is too costly. It costs > > around 0.085 > > > EUR. > > > >>> 0.085 EUR may seem low cost, but multiplied by > thousands > > it's > > > expensive. > > > >>> > > > >>> So, there must be a way to connect M2M through > Internet, > > i.e. > > > GPRS? Am I > > > >>> right? Does gammu allow this? > > > >>> > > > >>> I can get HTTP pages with AT commands. Does gammu > allow an > > > abstraction > > > >>> layer on top of AT commands to get HTTP pages? > > > >>> > > > >>> Thanks. > > > >>> > > > >>> João M. S. Silva > > > >>> > > > >>>> On 10/27/2015 04:02 AM, gilberto dos santos > alves wrote: > > > >>>> hi. may be these are questions for your telecom > > operator. using > > > >>>> gammu-smsd (daemon) you could exchange sms > between then > > like http > > > >>>> servers, ftp servers! what i miss in your question? > > > >>>> > > > >>>> 2015-10-26 16:26 GMT-02:00 João M. S. Silva > > > >>>> <[email protected] > <mailto:[email protected]> > > <mailto:[email protected] > <mailto:[email protected]>> > > > <mailto:[email protected] > <mailto:[email protected]> > > <mailto:[email protected] > <mailto:[email protected]>>> > > > <mailto:[email protected] > <mailto:[email protected]> > > <mailto:[email protected] > <mailto:[email protected]>> > > > <mailto:[email protected] > <mailto:[email protected]> > <mailto:[email protected] > <mailto:[email protected]>>>>>: > > > >>>> > > > >>>> Hi, > > > >>>> > > > >>>> How can I establish a session-based M2M > connection with > > > gammu? I'm using > > > >>>> hardware module SIM800L and a 4G SIM card. > I can do USSD > > > and SMS with > > > >>>> gammu, but USSD can only be used to > communicate with the > > > operator > > > >>>> network, not other SIM card, and SMS is > costly since > > > even for 10 chars > > > >>>> we must pay the price of an SMS. So, I'm > looking for a > > > session-based > > > >>>> connection where I pay for the traffic. > > > >>>> > > > >>>> If gammu does not allow this, is there an > alternative? > > > >>>> > > > >>>> Thanks. > > > >>>> > > > >>>> -- > > > >>>> João M. S. Silva > > > >>>> > > > >>>> > > > > ------------------------------------------------------------------------------ > > > >>>> _______________________________________________ > > > >>>> Gammu-users mailing list - > > > > >>>>https://lists.sourceforge.net/lists/listinfo/gammu-users > > > >>>> > > > >>>> > > > >>>> > > > >>>> > > > >>>> -- > > > >>>> gilberto dos santos alves > > > >>>> +55(11)9-8646-5049 > <tel:%2B55%2811%299-8646-5049> <tel:%2B55%2811%299-8646-5049> > > <tel:%2B55%2811%299-8646-5049> > > > >>>> sao paulo - sp - brasil > > > >>>> > > > >>>> > > > >>>> > > > >>>> > > > >>>> > > > >>>> > > > >>>> > > > > > > ------------------------------------------------------------------------------ > > > >>>> > > > >>>> > > > >>>> > > > >>>> _______________________________________________ > > > >>>> Gammu-users mailing list - > > > https://lists.sourceforge.net/lists/listinfo/gammu-users > > > >>> > > > > > > ------------------------------------------------------------------------------ > > > >>> _______________________________________________ > > > >>> Gammu-users mailing list - > > > https://lists.sourceforge.net/lists/listinfo/gammu-users > > > >>> > > > >>> > > > > > > ------------------------------------------------------------------------------ > > > >>> _______________________________________________ > > > >>> Gammu-users mailing list - > > > https://lists.sourceforge.net/lists/listinfo/gammu-users > > > >> > > > >> > > > > > > ------------------------------------------------------------------------------ > > > >> _______________________________________________ > > > >> Gammu-users mailing list - > > > https://lists.sourceforge.net/lists/listinfo/gammu-users > > > >> > > > > > > > > > > ------------------------------------------------------------------------------ > > > > _______________________________________________ > > > > Gammu-users mailing list - > > > https://lists.sourceforge.net/lists/listinfo/gammu-users > > > > > > > > > > > > ------------------------------------------------------------------------------ > > > _______________________________________________ > > > Gammu-users mailing list - > > > https://lists.sourceforge.net/lists/listinfo/gammu-users > > > > > > > > > > > > > > > -- > > > gilberto dos santos alves > > > +55(11)9-8646-5049 <tel:%2B55%2811%299-8646-5049> > <tel:%2B55%2811%299-8646-5049> > > > sao paulo - sp - brasil > > > > > > > > > > > > > > > > > > > > > > > > ------------------------------------------------------------------------------ > > > > > > > > > > > > _______________________________________________ > > > Gammu-users mailing list - > > https://lists.sourceforge.net/lists/listinfo/gammu-users > > > > > > > > ------------------------------------------------------------------------------ > > _______________________________________________ > > Gammu-users mailing list - > > https://lists.sourceforge.net/lists/listinfo/gammu-users > > > > > > > > > > > ------------------------------------------------------------------------------ > > > > > > > > _______________________________________________ > > Gammu-users mailing list - > https://lists.sourceforge.net/lists/listinfo/gammu-users > > > > ------------------------------------------------------------------------------ > _______________________________________________ > Gammu-users mailing list - > https://lists.sourceforge.net/lists/listinfo/gammu-users > > > > > -- > gilberto dos santos alves > +55(11)9-8646-5049 > sao paulo - sp - brasil > > > > > > > ------------------------------------------------------------------------------ > > > > _______________________________________________ > Gammu-users mailing list - https://lists.sourceforge.net/lists/listinfo/gammu-users > ------------------------------------------------------------------------------ _______________________________________________ Gammu-users mailing list - https://lists.sourceforge.net/lists/listinfo/gammu-users