Re: Problem occurred internal to model specific code

After some research, I was able to get rid of the issue by telling the
modem to avoid them thru minicom.

Stdout from smsd shoot "Unsolicited frame, skipping..." when it detects.

At least so far I do not see this affecting the libgnokii behavior, but
need more troubleshooting on production and with a little bit load.

Will keep you posted.

Rgds,

On Mon, 2013-12-09 at 16:10 -0300, Rodrigo Montiel wrote:
> First of all, thanks for your response, it is much appreciated.
> 
> I was wondering if those "STIN: 1,0,0" are rubbished messages from the
> past? or maybe some memory positions in the SM card? 
> 
> Will try to find out how to disable them manually, then will give a try
> on a connect/disconnect script.
> 
> Thank you,
> 
> On Mon, 2013-12-09 at 19:31 +0100, Daniele Forsi wrote:
> > 2013/12/9 Rodrigo Montiel:
> > 
> > > Maybe there are incompatibilities or something that I am not aware of?
> > 
> > libgnokii gets confused by those ^STIN: 1, 0, 0 messages but it should
> > work fine if you can disable them
> > 
> > if the modem command to disable them isn't permanent, ie you need to
> > issue it after every ATZ, then you need to use the git version of
> > gnokii (actually commit 6248e1d564cb1f528fc963301534136f7f190b50
> > should be enough) and a connect_script to issue the command
> > 
> > see in Docs/sample/ppp/ for examples of connect scripts
> > 
> > since this problem is likely to affect all users if that device, if
> > you can provide a script I'll be happy to add it
> > 
> > you need to experiment but the script can be as simple as
> > Docs/sample/ppp/portech-logout
> > 
> 
> 
> 
> _______________________________________________
> gnokii-users mailing list
> [email protected]
> https://lists.nongnu.org/mailman/listinfo/gnokii-users

-- 
Rodrigo Montiel
Ing. en Telecomunicaciones
Elastix Certified Engineer ECE#209728189
Mikrotik Certified MTCNA#1210NA066

Cel: +549 351 2581376

Freetech Solutions
www.freetechsolutions.com.ar
Tel/Fax: +54 351 6387585