Re: How to debug my wpa_supplicant connection ?
Pierre Couderc <[email protected]>
| Newsgroups | gmane.linux.drivers.hostap |
|---|---|
| Message-ID | <[email protected]> |
Thank you very much On 3/1/20 4:03 PM, Jouni Malinen wrote: > On Sun, Mar 01, 2020 at 09:10:51AM +0100, Pierre Couderc wrote: >> The point is that "couderc" is selected instead of "TPLINK_2872" (the 1rst >> in /etc/wpa_supplicant/wpa_supplicant-wlp1s0.conf) >> . > Do the configured network profiles have different priority setting? Do > they have different security parameters? Sorry, I am a beginner, I suppose that a "network profile" is an entry etc/wpa_supplicant/wpa_supplicant-wlp1s0.conf. No, I have not found in the man how to set a priority, I did suppose it was the order in .conf. Yes, the wanted hotspot (including TPLINK_2872) have : key_mgmt=NONE and less desired network profile have entries as defined by wpa_passphrase. > >> wpa_supplicant selects a far weak hot spot instead or a near strong one. > > wpa_supplicant debug log should include details about network selection > at the point when the scan results are processed for the initial > connection. OK, I shall add more verbose -dd instead of -d in my .service filr Thank you again PC _______________________________________________ Hostap mailing list [email protected] http://lists.infradead.org/mailman/listinfo/hostap