[PATCH] mesh: encapsulate VHT property with the proper CONFIG entry
Arturo Buzarra <[email protected]>
| Newsgroups | gmane.linux.drivers.hostap |
|---|---|
| Message-ID | <[email protected]> |
Committ e5a9b1e8a3 ("mesh: Implement use of VHT20 config in mesh mode")
introduced the possibility to check the disable_vht param, however this
entry is only available when CONFIG_VHT_OVERRIDES is enabled
Signed-off-by: Arturo Buzarra <[email protected]>
---
wpa_supplicant/wpa_supplicant.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/wpa_supplicant/wpa_supplicant.c b/wpa_supplicant/wpa_supplicant.c
index 839afe32d..ba8ae65ae 100644
--- a/wpa_supplicant/wpa_supplicant.c
+++ b/wpa_supplicant/wpa_supplicant.c
@@ -2394,12 +2394,14 @@ void ibss_mesh_setup_freq(struct wpa_supplicant *wpa_s,
freq->channel = pri_chan->chan;
#ifdef CONFIG_HT_OVERRIDES
if (ssid->disable_ht40) {
+#ifdef CONFIG_VHT_OVERRIDES
if (ssid->disable_vht)
return;
+#endif /* CONFIG_VHT_OVERRIDES */
goto skip_ht40;
}
#endif /* CONFIG_HT_OVERRIDES */
/* Check/setup HT40+/HT40- */