Setup hostapd as a DPP Responder

Hi, 

Is it possible to setup hostapd as a DPP responder and configurator that can provision clients with a DPP connector? 

If so, could you put together some instructions on how to do this?

I was able to follow the updated instructions in README-DPP: http://w1.fi/cgit/hostap/plain/wpa_supplicant/README-DPP, but this setup requires the configurator to initiate DPP Authentication. 

I am trying to setup hostapd to do the following with a generic client:

1. Generate a DPP URI as the configurator. 
2. Scan the DPP URI encoded as a QR-Code with a client device. 
3. Have the client device initiate DPP Authentication with hostapd and receive a DPP Connector.

Thanks,

Wystan Schmidt
Charter Communications
 
 

E-MAIL CONFIDENTIALITY NOTICE: 
The contents of this e-mail message and any attachments are intended solely for the addressee(s) and may contain confidential and/or legally privileged information. If you are not the intended recipient of this message or if this message has been addressed to you in error, please immediately alert the sender by reply e-mail and then delete this message and any attachments. If you are not the intended recipient, you are notified that any use, dissemination, distribution, copying, or storage of this message or any attachment is strictly prohibited.

_______________________________________________
Hostap mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/hostap