Re: EAP authenticator place in the hostapd.conf

You will get these configuration errors when CONFIG_NO_RADIUS is
enabled as a compile-time option in your .config file.

To avoid these errors, comment out the setting as shown below, and
recompile hostapd.

#CONFIG_NO_RADIUS=y


On Wed, Apr 22, 2020 at 11:14 AM <[email protected]> wrote:
>
> Hi,
>
> I want to configure hostapd as an AP to authenticate via wired interface
> STA(tions) against a freeradius server.
>
> This is my config
>
> # cat /etc/hostapd.conf | grep ^[^#]
> interface=eth0
> logger_syslog=-1
> logger_syslog_level=2
> logger_stdout=-1
> logger_stdout_level=2
> ctrl_interface=/var/run/hostapd
> ctrl_interface_group=0
> ieee8021x=1
> eapol_version=2
> eapol_key_index_workaround=0
> eap_reauth_period=3600
> own_ip_addr=192.168.200.236
> auth_server_addr=192.168.200.120
> auth_server_port=1812
> auth_server_shared_secret=*secret*
>
> Which results in errors
>
> # hostapd /etc/hostapd.conf
> Configuration file: /etc/hostapd.conf
> Line 1057: unknown configuration item 'auth_server_addr'
> Line 1058: unknown configuration item 'auth_server_port'
> Line 1059: unknown configuration item 'auth_server_shared_secret'
> Invalid IEEE 802.1X configuration (no EAP authenticator configured).
> 4 errors found in configuration file '/etc/hostapd.conf'
> Failed to set up interface with /etc/hostapd.conf
> Failed to initialize interface
>
> Why?
>
> How and where in the config  can I set the right EAP authenticator?
>
> Thanks,
> Erwin
>
>
>
> _______________________________________________
> Hostap mailing list
> [email protected]
> http://lists.infradead.org/mailman/listinfo/hostap