Re: AP Isolate Has No Effect
Thomas Pedersen <[email protected]> Wed, 17 Jun 2020 23:01:03 -0700
| Newsgroups | gmane.linux.drivers.hostap |
|---|---|
| Message-ID | <[email protected]> |
On 2020-06-17 23:00, Thomas Pedersen wrote: > On 2020-06-14 13:10, Hooman wrote: >> I have created a WiFi hotspot using Ubuntu 20.04. Under the hood it >> uses >> wpa_supplicant to create the AP. I'm trying to enable client >> isolation, >> so that devices on the hotspot network cannot send packets to each >> other. So once the hotspot is set up, I do the following: >> >> #sudo wpa_cli -i wlan0 >> >>> set ap_isolate 1 >> OK >>> get ap_isolate >> 1 >> >> So I see that AP isolate is enabled. However, I still can send packets >> from one device to another on the hotspot network. Why is that? Am I >> missing something? > > Are the AP and STA interfaces on a bridge with hairpinning enabled? Sorry, obviously meant just the AP interface. -- thomas _______________________________________________ Hostap mailing list [email protected] http://lists.infradead.org/mailman/listinfo/hostap