Re: printing slows system to a crawl

Interesting... What version of ghostscript are you using? Also, I know
that there hasn't been a version bump yet but can you also try
hpijs-1.6? Also, it is a good idea to keep the usb stuff modular. Also
kernel-2.6.xx?

Thanks,
Cory



On Thu, 2004-06-10 at 20:41, mail_acct wrote:
> Hi - 
> 
> Been searching around (this list, HP's site, Usenet) and am not getting
> anywhere.  My setup:
> 
> HP OfficeJet 6110 MFP (USB)
> cups-1.1.20-r1
> hpoj-0.91-r3
> hpijs-1.5
> kernel 2.6
> (gentoo; devfsd-1.3.25-r6)
> AMD 1.6GHz, 768M RAM, 1G swap
> 
> Whether I'm printing or scanning my system grinds to a halt
> (practically) during the entire time until the printed document is spit
> out - something is definitely out of whack.  Other than that everything
> works fine.  I also use jpilot to sync my PDA via USB and have no
> noticeable problems so don't necessarily know if this is a USB-related
> problem.  I use ~/.toprc to set top to a frequent update and AFAICT I
> don't see anything hogging CUP/MEM.
> 
> I don't know what other info to provide but can someone tell me if
> there's some cfg I'm missing?  Or if something (known) is broken?  I
> normally load all USB/print/scan as modules but tried compiling into
> kernel with no improvement.
> 
> Mike


-------------------------------------------------------
This SF.Net email is sponsored by the new InstallShield X.
From Windows to Linux, servers to mobile, InstallShield X is the
one installation-authoring solution that does it all. Learn more and
evaluate today! http://www.installshield.com/Dev2Dev/0504