scanning and printing problem with hpoj-0.91

Hello!

I'm new to this list. I've got some huge problems using the hpoj drivers 
on Suse 9.0 pro with my PSC 950.
My english is not the best, so I hope you can understand my problems...

A longer time ago I compiled the 0.90 drivers and installed them. 
Everything worked fine...almost.
The printer worked, even the card reader (using mtools).
But as soon as I scan something, the printer doesn't work anymore. I had 
to plug the USB cord off and in again, then setup the printer again with 
YaST2. Then I was able to print again.

After some frustration because of this I decided to install the 0.91 
version of the drivers.

Now I can scan, use the card readers but I'm not able to print anymore.
Only if I plug off the USB cord for some seconds and then plug it in 
again (hardware detection), then setup the printer with YaST2, I can 
print.....
After a reboot the printer doesn't work anymore and ptal-mlcd shows an 
error message at boot. Then I have to do all the same things again...

I think this is an issue with the drivers..........isn't it?

Best regards

Christian




-------------------------------------------------------
This SF.Net email sponsored by Black Hat Briefings & Training.
Attend Black Hat Briefings & Training, Las Vegas July 24-29 - 
digital self defense, top technical experts, no vendor pitches, 
unmatched networking opportunities. Visit www.blackhat.com