Re: psc1340 / psc_1300_series print connection failed after reboot

setting up in CUPS with localhost:631/admin, connected to PTAL device, using 
hpijs; worked fine after the installation.

after reboot printing failed and when I go through the Cups setup once more 
there is a massage: PTAL device not found.


in the bash:
 # ptal-connect mlc:usb:psc_1300_series -service PTAL_MLCP_DUMP
ptal-connect: connecting to device "mlc:usb:psc_1300_series"...  failed!

I don't know what changes after reboot

Joachim


Nachricht vom Dienstag 12 Oktober 2004 17:44 :
> What are the error messages that you are receiving? How are you going
> about setting up the printer in CUPS?
>
> Cory
>
> On Mon, 2004-10-11 at 22:01, Dr. Joachim Völcker wrote:
> > using Suse 8.1 and compiling hpoj-0.91 (including libusb, libusb-devel);
> > with psc1340 scaning and printing (cupps) worked after installation.
> >
> > After reboot only scaner works, ptal-print connection failed
> > ptal-init starts before cupps;
> > fstab mounts the device;
> > Any ideas? Which kernel-modules are nessesary?
> >
> > Joachim
> >
> >
> >
> >
> >
> > -------------------------------------------------------
> > This SF.net email is sponsored by: IT Product Guide on ITManagersJournal
> > Use IT products in your business? Tell us what you think of them. Give us
> > Your Opinions, Get Free ThinkGeek Gift Certificates! Click to find out
> > more http://productguide.itmanagersjournal.com/guidepromo.tmpl
> >
> > _______________________________________________
> > hpoj-devel mailing list
> > [email protected]
> > https://lists.sourceforge.net/lists/listinfo/hpoj-devel



-------------------------------------------------------
This SF.net email is sponsored by: IT Product Guide on ITManagersJournal
Use IT products in your business? Tell us what you think of them. Give us
Your Opinions, Get Free ThinkGeek Gift Certificates! Click to find out more
http://productguide.itmanagersjournal.com/guidepromo.tmpl