Re: saned debug

You need to run ptal-init setup and specify an IP address to create a
new port to the device.

Cory
hp linux printing team

On Fri, 2004-10-15 at 01:56, Heiko Günther wrote:
> Hi,
> i have a problem setting up network scanning on my linux box. I'm using 
> a multifunctional HP scanner device through the hpoj backend. local 
> scanning is working and "scanimage -L" lists my device as well.
> I configured the device for network scanning. for this, i have to run 
> "saned", right? "saned -d" prints the following error message:
> 
> [saned] main: starting debug mode (level 2)
> [saned] main: [0] socket failed: Address family not supported by protocoll
> [saned] main: [1] bind failed: Address already in use
> [saned] main: couldn't bind an address. Exiting.
> 
> What does that meen? Which address?
> sane version: 1.0.12
> sane-utils: 1.0.14
> 
> Thank you for your support!
> 
> Heiko


-------------------------------------------------------
This SF.net email is sponsored by: IT Product Guide on ITManagersJournal
Use IT products in your business? Tell us what you think of them. Give us
Your Opinions, Get Free ThinkGeek Gift Certificates! Click to find out more
http://productguide.itmanagersjournal.com/guidepromo.tmpl