Re: Connecting to an HP Officejet 7310 over ethernet with sane and HPOJ

Install hpoj. Run #ptal-init setup. In there you can specify the ip
address of your device. Also, be sure to uncomment #hpoj in
/etc/sane/conf.dll


Cory
hp linux printing team

On Tue, 2004-11-02 at 21:10, Sunil William Savkar wrote:
> Is there any way to use my officejet 7310 with sane as a driver.  The
> officejet is connected via its ethernet port, so it is not directly
> connected via USB.
> 
> I have seen references to the HPOJ backend and to the jetdirect system.  I
> am using the HP jetdirect interface for printing without problems, but
> scanning is a different issue.
> 
> So far I tried to add the Officejet's IP address to net.conf, changed
> dll.conf to reference net, but otherwise I don't quite see what I can do
> to get sane to reach across the network.
> 
> Any help would be greatly appreciated!
> 
> Sunil
> 
> 
> 
> 
> 
> -------------------------------------------------------
> This SF.Net email is sponsored by:
> Sybase ASE Linux Express Edition - download now for FREE
> LinuxWorld Reader's Choice Award Winner for best database on Linux.
> http://ads.osdn.com/?ad_id=5588&alloc_id=12065&op=click
> 
> _______________________________________________
> hpoj-devel mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/hpoj-devel


-------------------------------------------------------
This SF.Net email is sponsored by:
Sybase ASE Linux Express Edition - download now for FREE
LinuxWorld Reader's Choice Award Winner for best database on Linux.
http://ads.osdn.com/?ad_id=5588&alloc_id=12065&op=click