Re: Problem with configuring HP Officejet 6110 all-in-one software

Does dmesg say that you have a device connected? What usb modules are
loaded?

Cory
hplip team

On Sat, 2005-01-08 at 13:22 -0800, Jack Denman wrote:
> I am running SuSE 9.2 Pro and have the HP Officejet rpm installed. I
> can't get it configured.  It works on (ugh) Windows but even Windows
> won't give me the actual USB serial device it is using.
> 
> usbview gives me a message that states
> Error /proc/bus/usb/devices does not exist.
> 
> 
> The ptal-init setup command fails as listed below. My question is "How
> can I get it installed?"
> 
> Jack Denman
> 
> ************************************
> 
> lanya:~ # ptal-init setup
> 
> Stopping the HP OfficeJet Linux driver.
> 
> ----------------------------------------------------------------------
> 
> This program manages devices controlled by the HP OfficeJet Linux
> driver (hpoj).  It attempts to probe your computer for local parallel-
> and USB-connected devices, and allows you to specify network addresses
> for remote JetDirect-connected devices.
> 
> If you experience any difficulties in detecting your device(s), then
> refer to the hpoj documentation for troubleshooting information.
> 
> ----------------------------------------------------------------------
> 
> Currently defined device names ([*]=default):
>     (none)
> 
> ----------------------------------------------------------------------
> 
> Probe for parallel-connected devices ([y]/n)?  n
> 
> ----------------------------------------------------------------------
> 
> Probe for USB-connected devices ([y]/n)?  y
> 
> Probing "/dev/usb/lp0"...
>     No device found.
> 
> Probing "/dev/usb/lp1"...
>     No device found.
> 
> Probing "/dev/usb/lp2"...
>     No device found.
> 
> Probing "/dev/usb/lp3"...
>     No device found.
> 
> Probing "/dev/usb/lp4"...
>     No device found.
> 
> Probing "/dev/usb/lp5"...
>     No device found.
> 
> Probing "/dev/usb/lp6"...
>     No device found.
> 
> Probing "/dev/usb/lp7"...
>     No device found.
> 
> Probing "/dev/usblp0"...
>     No device found.
> 
> Probing "/dev/usblp1"...
>     No device found.
> 
> Probing "/dev/usblp2"...
>     No device found.
> 
> Probing "/dev/usblp3"...
>     No device found.
> 
> ----------------------------------------------------------------------
> 
> Press <Enter> alone to continue, or if you would like to add a
> JetDirect-connected device, then enter its dotted-decimal
> IP address or hostname here --->
> 
> ----------------------------------------------------------------------
> 
> Done updating device configuration files stored under /etc/ptal.
> If you make manual changes to those files, then be sure to run
> "/usr/sbin/ptal-init start" so they will take effect.
> 
> ----------------------------------------------------------------------
> 
> Starting the HP OfficeJet Linux driver.
>     No hpoj devices have been configured.
>     As root, run "/usr/sbin/ptal-init setup".
> 
> lanya:~ #                                                          
> 
> -- 
> Jack Denman <cashmere-iVX72re7JJ/[email protected]>



-------------------------------------------------------
The SF.Net email is sponsored by: Beat the post-holiday blues
Get a FREE limited edition SourceForge.net t-shirt from ThinkGeek.
It's fun and FREE -- well, almost....http://www.thinkgeek.com/sfshirt