Re: hp photosmart 2610 and card reader access

Joe Piolunek <[email protected]> Thu, 10 Feb 2005 09:31:19 -0500
Newsgroups gmane.linux.drivers.hpofficejet.devel
Message-ID <[email protected]>
On Thursday 10 February 2005 07:55, Øyvind Hagen wrote:
> I tried using only hplip, but then neither printing nor scanning worked.
> Since there was a conflict between hplip and hpoj in debian, I had to
> download the sources for hplip. I then tried to use hpoj for scanning
> and printing, which worked just fine. The device URI is
> "ptal:/hpjd:192.168.2.205" and the printer is "hprint". I then tried:
>
> root:/usr/local/share/hplip# ./photo -phprint
>   HP Linux Imaging and Printing System (ver. 0.8.8)
>   Photo Card Access Utility ver. 3.0
>   Copyright (c) 2003-4 Hewlett-Packard Development Company, LP
>   This software comes with ABSOLUTELY NO WARRANTY.
>   This is free software, and you are welcome to distribute it
>   under certain conditions. See COPYING file for more details.
>
>   [WARNING]: Malformed/non-HP URI: ptal:/hpjd:192.168.2.205

It looks like you haven't set up a new queue for use with hplip. Assuming you 
use CUPS, in the cups browser interface, choose device "AppSocket/Hp 
JetDirect", then enter a device URI that hplip understands. Supposedly you 
can find the correct URI by running

hplip]$ /usr/share/hplip/probe -bnet (with the printer on)

For some reason, I haven't yet been able to use hplip/probe on my system (even 
with iptables stopped). If you can't get it to work for you, try using this 
device URI in CUPS:

hp:/net/Photosmart_2600_series?ip=192.168.x.x (use your printer's IP address)


If you want to leave hpoj installed, you will need to stop it before starting 
hplip, because they cannot be run at the same time.

On my FC1 system:

]# /etc/init.d/ptal-init stop
]# /etc/init.d/hplip start

I have hplip start at boot instead of hpoj:

]# /sbin/chkconfig --del ptal-init
]# /sbin/chkconfig --add hplip


A further note: I just installed the latest hplip (0.8.8) and am having some 
trouble with it. hplip-0.8.7 works pretty well for me, though there are a few 
issues here that may or may not be related to my system (mis?)configuration.

I'm interested in hearing your results.

-- 
Joe Piolunek


-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users.
Discover which products truly live up to the hype. Start reading now.
http://ads.osdn.com/?ad_ide95&alloc_id396&op=click