Re: Linux Newbie, psc 1210 install issues

Ron Crummett <[email protected]> Thu, 11 Aug 2005 13:33:56 -0700
Newsgroups gmane.linux.drivers.hpofficejet.devel
Message-ID <[email protected]>
Mark -

I've gone through and run the commands you suggested.  I have put my 
results after your suggestions.

Mark Purcell wrote:

>On Thursday 11 August 2005 20:31, Ron Crummett wrote:
>  
>
>>I installed Debian Sarge on my laptop about three weeks ago, so I am
>>still very new to all of this.  I feel like I have learned a lot in a
>>short time, but I can't seem to figure out how to install my HP PSC 1210
>>multifunction to print and scan.
>>    
>>
>
>Hi Ron,
>
>I'm the Debian GNU/Linux maintainer for hpoj and I have a HP PSC 1215, which I 
>think is very close to the 1210 as I am using the 1210 drivers!
>
>I can assure you that scanning and printing do work at the same time.  The 
>Debian packages have all the enhancements from the CVS version.
>
>Can you confirm which version of hpoj you have installed via debian?  
>	`dpkg -l hpoj`
>
>Also please confirm that hpoj isn't commented out of /etc/sane.d/dll.conf, 
>that should be automatic, but you never know.
>  
>
No, it's not commented out.

>  
>
>>Scanning works using the HPOJ <http://hpoj.sourceforge.net/> low-level
>>driver together with its SANE <http://www.sane-project.org/> backend
>>"hpoj". However, note that when using the current version (0.9) you can
>>only scan, and when you don't use HPOJ at all you can only print. To fix
>>this so you can both print and scan, you MUST install libusb
>><http://libusb.sourceforge.net> and upgrade to the CVS version of HPOJ
>><http://hpoj.sourceforge.net>.
>>    
>>
>
>You should be using version 0.91 if you got it from sarge. Not 0.9 which is an 
>older version.
>  
>

I'm using 0.91-4.

>  
>
>>So, if I got this right, I need to install libusb and upgrade to the CVS
>>version of HPOJ.  Can someone explain how I do this?  My attempts to
>>install libusb (the most recent release) get foiled at the build stage,
>>and I can't find anything regarding a CVS version of HPOJ on the site.
>>I am looking forward to hearing your words of advice.  Thanks in advance.
>>    
>>
>
>No you don't need to do that.
>
>Make sure you have 0.91 from sarge:
>
>Here's my setup
>
>Make sure you following the instructions 
>at /usr/share/doc/hpoj/html/setup-scan.html
>  
>

This might be part of the problem.  That file doesn't exist.  I have no 
hpoj directory in /usr/share/doc, though I am told that hpoj is installed.

>msp@debian:~$ scanimage --list-devices
>device `hpoj:mlc:usb:psc_1200_series' is a Hewlett-Packard psc 1200 series 
>multi-function peripheral
>  
>

device `hpaio:/usb/psc_1200_series?serial=<serial #>' is a hp 
psc_1200_series multi-function peripheral

>msp@debian:~$ dpkg -l hpoj
>Desired=Unknown/Install/Remove/Purge/Hold
>| Status=Not/Installed/Config-files/Unpacked/Failed-config/Half-installed
>|/ Err?=(none)/Hold/Reinst-required/X=both-problems (Status,Err: 
>uppercase=bad)
>||/ Name                      Version                   Description
>+++-=========================-=========================-==================================================================
>ii  hpoj                      0.91-4                    HP OfficeJet Linux 
>driver (hpoj)
>  
>

    rc   hpoj                                                      
0.91-4                                                  HP OfficeJet 
Linux driver (hpoj)

>Mark
>
>
>-------------------------------------------------------
>SF.Net email is Sponsored by the Better Software Conference & EXPO
>September 19-22, 2005 * San Francisco, CA * Development Lifecycle Practices
>Agile & Plan-Driven Development * Managing Projects & Teams * Testing & QA
>Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf
>
>_______________________________________________
>hpoj-devel mailing list
>[email protected]
>https://lists.sourceforge.net/lists/listinfo/hpoj-devel
>  
>
I hope that this helps.  I do have a question regarding hpoj, however.  
When I run the commands you suggest I am given a version number, but 
when I look at uninstalled packages under aptitude, hpoj 0.91-4 is 
listed as not installed.  I have been hesitant to install it because 
doing so uninstalls hplip.

Thanks again!

Ron Crummett


-------------------------------------------------------
SF.Net email is Sponsored by the Better Software Conference & EXPO
September 19-22, 2005 * San Francisco, CA * Development Lifecycle Practices
Agile & Plan-Driven Development * Managing Projects & Teams * Testing & QA
Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf