Re: [ANNOUNCE] ipw2200-1.2.2 is available for download
Kenneth Crudup <[email protected]>
| Newsgroups | gmane.linux.drivers.ipw2100.devel |
|---|---|
| Message-ID | <[email protected]> |
On Thu, 12 Jul 2007, Zhu Yi wrote:
> > * Fix ipw2200 set wrong power parameter causing firmware error
On Thu, 12 Jul 2007, Kenneth Crudup wrote:
> I'm guessing this is why I tend to get these during low-signal operation?
Apparantly not:
----
Jul 12 12:46:46 vaio kernel: ipw2200: Firmware error detected. Restarting.
# iwconfig eth0
eth0 IEEE 802.11g ESSID:"ozt" Nickname:"vaio"
Mode:Managed Frequency:2.462 GHz Access Point: 00:18:F8:BB:33:D0
Bit Rate:54 Mb/s Tx-Power=20 dBm Sensitivity=8/0
Retry limit:7 RTS thr:off Fragment thr:off
Encryption key:FC1C-7D16-A742-6EB5-B2C9-C3A1-DD73-2810 Security mode:open
Power Management:off
Link Quality=42/100 Signal level=-52 dBm Noise level=-90 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:27
----
-Kenny
--
Kenneth R. Crudup Sr. SW Engineer, Scott County Consulting, Los Angeles
O: 3630 S. Sepulveda Blvd. #138, L.A., CA 90034-6809 (888) 454-8181
-------------------------------------------------------------------------
This SF.net email is sponsored by DB2 Express
Download DB2 Express C - the FREE version of DB2 express and take
control of your XML. No limits. Just data. Click to get it now.
http://sourceforge.net/powerbar/db2/