Re: create / generate a new hal / public / xxxx.hal.o.uu file

> Alternatively, you could use the Subversion trunk version of MadWifi,
> which has no binary blobs and should not have that issue at all.
>
Hi tried with trunk revison 4119.

[root@AntoPC001 madwifi-trunk]# make
KERNELPATH=/home/antonello/projects/imola4-lx/linux/linux-2.6.18
CROSS_COMPILE=mips-linux- info
The following settings will be used for compilation:
BUS          : PCI
KERNELRELEASE: 2.6.18.8
KERNELPATH   : /home/antonello/projects/imola4-lx/linux/linux-2.6.18
KERNELCONF   : /home/antonello/projects/imola4-lx/linux/linux-2.6.18/.config
KMODPATH     : /lib/modules/2.6.18.8/net
KMODSUF      : ko
[root@AntoPC001 madwifi-trunk]#

The compilation ends without problems.
Than, I tried to load module on the target board:

 # lspci -vvv
 00:01.0 Non-VGA unclassified device: Atheros Communications Inc. AR5413
802.11abg NIC
        Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort-<MAbort- >SERR- <PERR-
        Interrupt: pin ? routed to IRQ 25
        Region 0: [virtual] Memory at 1a000000 (32-bit, non-prefetchable)
[disabled] [size=64K]

 #
 # insmod ath_hal.ko
 # insmod wlan.ko
 # insmod ath_rate_sample.ko
 # insmod wlan_scan_ap.ko
 # insmod wlan_scan_sta.ko
 # insmod ath_pci.ko
 PCI: Enabling device 0000:00:01.0 (0000 -> 0002)
 MadWifi: unable to attach hardware: 'Hardware revision not supported'
(HAL stat)
 #

Where could be the problem?

Regards
Antonello

------------------------------------------------------------------------------
The Planet: dedicated and managed hosting, cloud storage, colocation
Stay online with enterprise data centers and the best network in the business
Choose flexible plans and management services without long-term contracts
Personal 24x7 support from experience hosting pros just a phone call away.
http://p.sf.net/sfu/theplanet-com