Re: Still unable to configure MadWifi as an AP

On Wed, 2010-06-02 at 21:25 -0400, Aditya Bhave wrote:
> If you see the lines next to ath0 in my output, it says mode: Master. Im 
> using a Lenovo Thinkpad as an AP. It has an in-built Intel-based WiFi 
> card which is showing up as wlan0 in the output of iwconfig. It doesnt 
> show in the output of ifconfig since I disabled it using "ifconfig wlan0 
> down."

Oh, I see it now.

> So I dont think theres a problem in my setting up the interface. Im 
> reposting the output of ifconfig, iwconfig and route -n for STA and AP 
> again below.

Try pinging AP on the station and vice versa.  Use wireshark on both
sides to see where the packets are lost.  Check iptables settings, maybe
you have strict firewall rules.

-- 
Regards,
Pavel Roskin

------------------------------------------------------------------------------
ThinkGeek and WIRED's GeekDad team up for the Ultimate 
GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the 
lucky parental unit.  See the prize list and enter to win: 
http://p.sf.net/sfu/thinkgeek-promo