Re: MadWifi driver fails to recognize Ubiquity card

Even with the trunk version, the same problem occurs. No wifi0 appears

--Aditya Bhave

On 07/14/2010 05:39 PM, Aditya Bhave wrote:
> what is relatively new code and not tested? The 0.9.4 branch or the
> trunk (SVN ??) version?
> I need to use Master mode and need access to OPenHal to enable 5/10 MHz
> channels. Are these facilities available in ath5k/9k?
>
> Thanks
> regards,
> Aditya Bhave
>
>
>
> On 07/14/2010 05:15 PM, Pavel Roskin wrote:
>    
>> On Wed, 2010-07-14 at 16:55 -0400, Aditya Bhave wrote:
>>
>>
>>      
>>> I compiled and installed the latest MadWifi code in the following way
>>>
>>> ayb@AD-DELL:~/Desktop/madwifi-0.9.4-r4133-20100621$ cd scripts
>>>
>>>        
>> ...
>>
>>
>>      
>>>           product: AR928X Wireless Network Adapter (PCI-Express)
>>>
>>>        
>> Support for AR9280 only exists in the trunk, not in the 0.9.4 branch.
>> It's relatively new code that received very little testing.  Besides,
>> 802.11n is not supported by MadWifi.  I suggest that you use ath9k if
>> you can.
>>
>>
>>      
>
> ------------------------------------------------------------------------------
> This SF.net email is sponsored by Sprint
> What will you do first with EVO, the first 4G phone?
> Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first
> _______________________________________________
> Madwifi-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/madwifi-users
>
>    


------------------------------------------------------------------------------
This SF.net email is sponsored by Sprint
What will you do first with EVO, the first 4G phone?
Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first