Re: Half and Quarter Channel Support??

  On 07/22/2010 01:35 PM, Shawn wrote:
> I am trying to use a Ubiquity XR9 in Half and Quarter channel modes, but I
> cannot get it to work.
>
> The managed stations sees the access point in half and quarter channel mode
> but they cannot associate to the AP. Works properly in full (20MHz) BW mode.
>
> I've done a ton of reading on here and the web, but I can't seem to get a
> straight answer: Is Half and Quarter channel operation supported by Madwifi? I
> guess particularly with the Ubiquity XR9 card. I spoke with the Ubiquity tech
> support guy and he tells me that Madwifi does NOT support 10MHz and 5MHz
> channels. Yet, I can get the Wiligear 2.4 cards to work in half bandwidth
> modes with Madwifi.... so confused now.
>
> If so, any ideas what could be wrong?
>
>
> ------------------------------------------------------------------------------
> This SF.net email is sponsored by Sprint
> What will you do first with EVO, the first 4G phone?
> Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first
> _______________________________________________
> Madwifi-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/madwifi-users
Setting the country to 5001 gives channel mappings for all 5, 10 and 20 
MHz channel widths.

The problem I had is that the scanner only used the first channel/width 
combo on each frequency. So, it only scanned 4 instead of the 10 
possible combinations.

Steve

------------------------------------------------------------------------------
This SF.net email is sponsored by Sprint
What will you do first with EVO, the first 4G phone?
Visit sprint.com/first -- http://p.sf.net/sfu/sprint-com-first