problem on mandrake 10.0

Hello,

After a fresh installation of Mandrake 10.0 Official (plus updates), I
have discovered that my old Rockwell/Conexant internal modem would work
with a linuxant HCF driver. After installing the following,

hcfpcimodem-1.01lnxt04111200full_k2.6.3_7mdk-1mdk.i586. rpm

I was able to go online without any problem. However, after my next
system bootup, the modem was no longer accessible. Yet the command

% rchcfpci restart

made the module again active. Now the problem is that the modem _always_
returns the signal BUSY after dialling. I have made all possible efforts
to solve this issue (reinstalling, compiling, disabling acpi and apic,
etc), all to no avail. Internet searches likewise did not yield any
useful hint.

Does anyone have any idea? I hope I could avoid buying a non-winmodem,
since I need to use dialup access only for a few months.

Thanks in advance

François C

_______________________________________________
hcflinux mailing list
[email protected]
https://www.linuxant.com/mailman/listinfo/hcflinux