Debian 3.1 + kernel 2.6.10 - busy after ATDT

Hi,

I have problems with runnig my HCF PCI modem on Debian 3.1 - Sarge, 
kernel 2.6.10, using 1.03 hcfpcimodem drivers.

After the ATDT command, modem ticks three times and returns BUSY.
(output from gnome-ppp:
  GNOME PPP: STDERR: --> WvDial: Internet dialer version 1.54.0
  GNOME PPP: STDERR: --> Initializing modem.
  GNOME PPP: STDERR: --> Sending: ATX3
  GNOME PPP: STDERR: ATX3
  GNOME PPP: STDERR: OK
  GNOME PPP: STDERR: --> Sending: ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
  GNOME PPP: STDERR: ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
  GNOME PPP: STDERR: OK
  GNOME PPP: STDERR: --> Sending: AT &F X3
  GNOME PPP: STDERR: AT &F X3
  GNOME PPP: STDERR: OK
  GNOME PPP: STDERR: --> Modem initialized.
  GNOME PPP: STDERR: --> Sending: ATM1L3DT971100811
  GNOME PPP: STDERR: --> Waiting for carrier.
  GNOME PPP: STDERR: ATM1L3DT971100811
  GNOME PPP: STDERR: BUSY
  GNOME PPP: STDERR: --> The line is busy. Trying again.
  GNOME PPP: STDERR: --> Sending: ATM1L3DT971100811
  GNOME PPP: STDERR: --> Waiting for carrier.
  GNOME PPP: STDERR: ATM1L3DT971100811
  GNOME PPP: STDERR: BUSY
  ...
  ... )
No matter what program I use for the dialing (wvdial, gnome-ppp, 
kppp...), the result is still same.
  

My box:
  AMD Athlon 650 MHz
  Via KX133 chipset (?)
  Well PCI-RWM-56 HCF based modem
    (lspci identifies as: "0000:00:08.0 Communication controller: 
Rockwell International HCF 56k PCI Speakerphone Modem (rev 08)")

The modem run well on Windows (98, XP) and used to run well on my old 
Mandrake 9.2-rc2 with 2.4.x kernel. I was using 0.99 drivers there, but 
I was unable to use them on the new kernel.

I found similar problems here on the list, and I tried suggested 
solutions, but none of them worked.

I'm enclosing the hcfdiag.txt.

Thanks for any help,

Mira,
Czech Republic

P.S. Sorry for any grammar/spelling/whatever mistakes...

_______________________________________________
hcflinux mailing list
[email protected]
https://www.linuxant.com/mailman/listinfo/hcflinux