Re: False "Busy signal detected" error

Hi,

you should try with the same initialization string with HylaFax that you 
have successfully used with 'minicom'. Alternatively, you could try with 
the 'AT &F X1' init. string with HylaFax.

You should also make sure that the right country is selected with the 
'hcfpciconfig --country' command in a root shell.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]



Mark Hellman wrote:
> Conexant HCF PCI modem + Linuxant's commercial driver version 1.07
> Hylafax 4.2.1
> SuSE Linux 9.1
> 
> Receiving fax with Hylafax has been working flawlessly for a few months.
> But a recurring problem happens when we try to send a fax: a "Busy
> signal detected" is reported by the modem even when the remote line is
> NOT busy.
> 
> Using minicom I can ATDT. But Hylafax can't. Do I need any special modem
> initialization string?
> 
> Here goes a Hylafax session transcript:
> 
> [12216]: SESSION BEGIN 000000240 352226975647
> [12216]: HylaFAX (tm) Version 4.2.1
> [12216]: SEND FAX: JOB 21 DEST 226975647 COMMID 000000240 DEVICE
> '/dev/modem'
> [12216]: STATE CHANGE: RUNNING -> SENDING
> [12216]: MODEM input buffering enabled
> [12216]: Apply DialString rules to "226975647"
> [12216]: --> return result "226975647"
> [12216]: <-- [14:AT+FCLASS=1.0\r]
> [12216]: --> [2:OK]
> [12216]: MODEM set XON/XOFF/FLUSH: input ignored, output disabled
> [12216]: DIAL 226975647
> [12216]: <-- [14:ATDT226975647\r]
> [12216]: --> [4:BUSY]
> [12216]: SEND FAILED: JOB 21 DEST 226975647 ERR Busy signal detected
> [12216]: <-- [5:ATH0\r]
> [12216]: --> [2:OK]
> [12216]: MODEM set DTR OFF
> [12216]: STATE CHANGE: SENDING -> MODEMWAIT (timeout 5)
> [12216]: SESSION END
> 
> 
> Thanks,
> Mark
> 
> _______________________________________________
> hcflinux mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/hcflinux