Re: Package building help needed

Hi,

instead attempting to convert the pre-compiled RPM package, a new target 
to the Makefile could be added, for example, slackdist and this target 
would generate the pre-compiled package for Slackware. I guess that some 
code from the rpmdist and debdist targets could be reused to code the 
new one.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]



robert w hall wrote:
> build the rpm then use rpm2tgz???
> Bob
> 
> In message <[email protected]>, Linuxant support (Jonathan)
> <[email protected]> writes
>> Hi,
>>
>> if I understand, you basically want to build pre-compiled package(s) for 
>> Slackware. You could use as example the 'rpmdist' and 'debdist' targets 
>> of the Makefile in the root of the driver TAR package, we use these to 
>> build the pre-compiled RPM and DEB packages available on our web site.
>>
>> Regards,
>>
>>
>> Jonathan
>> Technical specialist / Linuxant
>> www.linuxant.com
>> [email protected]
>>
>>
>>
>> Richard Harris wrote:
>>> I am using the hcfpci modem driver on a Slackware 10 desktop.
>>> I would like to build a package for the driver so that I can
>>> reload the box with the driver either ready-to-go or only needing
>>> the license key.
>>>
>>> Has anyone built such a package?
>>> Has anyone reloaded the driver in a similar way?
>>>
>>> Any help here would be appreciated.
>>>
>>> Richard Harris
>>>
>>> --
>>> - Pixel Fiction
>>> - Digital & BookOnDemand
>>> - http://billy-bob-ming.com
>>> --
>>>
>>>
>> _______________________________________________
>> hcflinux mailing list
>> [email protected]
>> https://www.linuxant.com/mailman/listinfo/hcflinux
>