Re: Re: hcfpcimodem-1.10 and Hylafax

Hi,

the modem driver is likely to work well using the defaults of the=20
program using it. If not, at this point, you could take a look to see if=20
there is a configuration option which is not correct or see if the modem=20
driver is actually working right.

For example, you could try to do a dial-up connection with the modem=20
just to make sure that it is working fine before you try advanced=20
features of the driver like FAX support.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]



Mark Hellman wrote:
> Mark Hellman wrote:
>=20
>> Hylafax's configuration script reported =ABThere is no prototype
>> configuration file for your modem=BB and proposed the following
>> configuration parameters:
>=20
> Well, since I rebooted the system, Hylafax's faxaddmodem script is able=
 to
> identify the modem. Here goes a transcript of the relevant section of
> faxaddmodem output:
>=20
>       This modem looks to have support for Class 1 and 1.0.
>       How should it be configured [1]? 1.0
>=20
>       Hmm, this looks like a Class 1.0 modem.
>       Product code (ATI0) is "56000".
>       Other information (ATI3) is "hcfpcimodem-1.10full".
>       DTE-DCE flow control scheme [default]?
>       Modem manufacturer is "Rockwell/Conexant".
>       Modem model is "AC/K56".
>=20
>       Using prototype configuration file conexant-1.0...
>=20
>       The modem configuration parameters are:
>=20
>       ModemFlowControl:       rtscts
>       ModemHardFlowCmd:       AT&K3
>       ModemNoFlowCmd:         AT&K0
>       ModemRate:              19200
>       ModemSetupDCDCmd:       AT&C1
>       ModemSetupDTRCmd:       AT&D2
>       ModemSoftFlowCmd:       AT&K4
>=20
> Should I change any of these values?
>=20
>=20
> Mark
>=20
> _______________________________________________
> hcflinux mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/hcflinux