Re: hcfpcimodem and x86_64

Hi,

the HCF PCI driver currently only works on x86. It is possible that we 
will release a x86_64 version of this driver in the future, if we do, we 
will contact you back.

Please note that even if you have a x86_64 system, you can install a 
32-bit (x86) Linux distribution and the current version of the HCF PCI 
driver should work fine with this setup.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]



Bev Null wrote:
> I have a 56K modem that works with the hcfpcimodem driver on my old computer.
> I just bought an Athlon 64 and installed Fedora Core 5 for x86_64 and wanted to
> transfer the modem to the new computer.
> 
> I didn't see any pre-built rpm's for the x86_64 architecture.  I tried installing the generic
> 'tar' file, but when it compiles it gives a bunch of warnings that it is not likely to work.
> And of course, it did not work.
> 
> Any suggestions?
> 
> Thanks!
> 
> Bev
> _______________________________________________
> hcflinux mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/hcflinux