Re: Conexant USB ID 0572:1328 and Kernel 2.4.32

Hi,

it seems that the driver doesn't answer to basic AT commands for an 
unknown reason. Like I already mentioned, you should try to use the 
modem with a low-level telecommunication software like minicom, it will 
be easier to see if this is a problem with the driver or not.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]



Alessandro Ferrari wrote:
> Hi Jonathan,
> 
>    I have configured USB-Conexant by hylafax's faxaddmodem utility. It 
> detects usb modem like as "MODEM CX93001-EIS_V0.2002-V92 56000/".
> 
>    So, I try to send fax but I read into log the same error:
> 
> ott 18 10:00:06.80: [ 4036]: SESSION BEGIN 00000381 35XXXXX
> ott 18 10:00:06.80: [ 4036]: HylaFAX (tm) Version 4.1.5
> ott 18 10:00:06.80: [ 4036]: SEND FAX: JOB 114 DEST 03512345 COMMID 
> 00000381 DEVICE '/dev/ttyACM0'
> ott 18 10:00:06.80: [ 4036]: DELAY 75 ms
> ott 18 10:00:06.88: [ 4036]: DELAY 2600 ms
> ott 18 10:00:09.49: [ 4036]: DELAY 10 ms
> ott 18 10:00:09.49: [ 4036]: <-- [4:ATZ\r]
> ott 18 10:00:39.49: [ 4036]: MODEM <Timeout>
> ott 18 10:00:39.49: [ 4036]: DELAY 75 ms
> ott 18 10:00:39.57: [ 4036]: DELAY 2600 ms
> ott 18 10:00:42.17: [ 4036]: DELAY 10 ms
> ott 18 10:00:42.18: [ 4036]: <-- [4:ATZ\r]
> ott 18 10:01:12.18: [ 4036]: MODEM <Timeout>
> ott 18 10:01:12.18: [ 4036]: SEND FAILED: JOB 114 DEST 03512345 ERR Can 
> not setup modem
> ott 18 10:01:12.18: [ 4036]: SESSION END
> 
>    I try to change AT command to fit reset software modem whitout success!
> 
>    Is it usb module's problem?
> 
> Alessandro
> _______________________________________________
> hcflinux mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/hcflinux