Re: HSF no carrier on SUSE 9.2 prof

"Linuxant support (Jonathan)" <[email protected]>
Newsgroups gmane.linux.drivers.modem.hsf
Organization Linuxant Inc.
Message-ID <[email protected]>
Hi,

please configure wvdial with the '/etc/wvdfial.conf' file to use:

---
AT &F X1
---

as the only init. string. Hopefully, it will fix the 'NO CARRIER' error 
message. Please also make sure that the right country is selected with 
the 'hsfconfig --country' command in a root shell.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]


Julie Sadler wrote:
> This post is a follow up from a post named newbie on hsf install (previously I had loaded FC 3 on a  dell inspiron 8200. I have 2 modems, one internal and the other on a pcmcia card. In the previous post and config, the hsf driver was found by linux, it dialed out once, and never dialed again. I got frustrated...and had an opportunity to try SUSE 9.2 pro, so i reloaded. At this point i have downloaded the hsf package again and installed it, and I am a bit further than before)
> 
> The modem is seen by my laptop, and it dials out. Then, it hangs. I hear nothing on the other end picking up...and eventually it will redial. Here is the ouput from the log of KPPP.
> 
> SuSE Meta pppd (smpppd-ifcfg), Version 1.50 on linux.
> Status is: disconnected
> trying to connect to smpppd
> connect to smpppd
> Status is: disconnected
> Status is: connecting
> pppd[0]: Plugin passwordfd.so loaded.
> pppd[0]: --> WvDial: Internet dialer version 1.54.0
> pppd[0]: --> Initializing modem.
> pppd[0]: --> Sending: ATZ
> pppd[0]: ATZ
> pppd[0]: OK
> pppd[0]: --> Sending: AT Q0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
> pppd[0]: AT Q0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
> pppd[0]: OK
> pppd[0]: --> Sending: ATM1
> pppd[0]: ATM1
> pppd[0]: OK
> pppd[0]: --> Modem initialized.
> pppd[0]: --> Sending: ATDT6135600
> pppd[0]: --> Waiting for carrier.
> pppd[0]: ATDT6135600
> pppd[0]: NO CARRIER
> pppd[0]: --> No Carrier!  Trying again.
> pppd[0]: --> Sending: ATDT6135600
> pppd[0]: --> Waiting for carrier.
> pppd[0]: ATDT6135600
> 
> I have already added the line to /etc/wvdial.conf that says "Carrier check = no"
> 
> NOW What?? I am so close, yet so far away!
> 
> (KERNEL VER. 2.6.8-24.11)
> 
> J>
> _______________________________________________
> hsflinux mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/hsflinux
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.